Dell EMC VxFlex Ready Node User Manual page 265

d. Click Next.
5. In the Security screen, type the passwords of the non-AMS-managed system
nodes.
Note: If you prepared a CSV file for your credentials, the password
information in that file will overwrite what is entered in this step. Type
passwords for these fields that meet the VxFlex OS criteria.
a. Type the host operating system password.
b. For ESXi systems, type the SVM password.
c. Type the BMC (iDRAC) password.
d. Type a new AMS recovery key.
This password is required for running the AMS recovery process. It must
meet the following criteria:
At least 7 characters long
l
Include at least 3 of the following groups: [a-z], [A-Z], [0-9], special
l
chars (!@#$ ...)
An uppercase character at the beginning of the password or a number at
l
the end of the password is not included in the count of character groups
e. Click Next.
6. In the Management Networks screen, type IP address ranges for the
management networks.
a. Select the IP address version (IPv4 or IPv6) in IP address version.
b. Type IP address ranges for each management network, using the options
described below.
Note: If the non-AMS-managed system has both ESXi and Linux nodes,
only type the addresses for the ESXi hosts in this step.
c. Click Next.
To do this
Use VLAN tagging
Define non-
contiguous IP
address ranges
Delete a line
7. In the Data Networks screen, type IP address ranges for each data network.
a. Select the IP address version (IPv4 or IPv6) in IP address version.
IPv6 is supported in RHEL environments only.
Use this
Select VLAN ID and type the ID. Use VLAN tagging to
separate the networks on different VLANs and assign a
VLAN ID. The host and the SVM should have the same
VLAN ID. Entering a VLAN ID of 0, or leaving the VLAN
ID field empty, will not enable VLAN tagging for that
network.
Click . Add the range in the line that appears.
Click .
Dell EMC VxFlex Ready Node AMS User Guide
Common Tasks
265