Table of Contents
Advertisement
Press Calibrate Left Sensor or Calibrate Right Sensor.
7.
A popup message appears to tell you if the calibration was successful. If calibration
failed, make sure that only the liner is in the supply path and try the calibration again.
C a l i b r a t i n g t h e T o u c h S c r e e n
Calibrate the touch screen so the buttons respond correctly when pressed. You are prompted to
do this the first time you turn the printer on after receiving it and after you update the printer's
Application Software.
screen instructions to calibrate the
touch screen. The application runs
automatically when you are finished.
Only touch the screen in the center of
the crosshair; make sure nothing
touches any other part of the screen
during calibration.
You can also calibrate the touch screen
if it does not correctly respond to touch.
Use a paperclip to press and hold the
button shown. Then follow the on-
screen instructions to calibrate the
touch screen
7-6 System Administrator's Guide
Follow the on-
Press and hold for 3 se con ds
Advertisement
Table of Contents
