Warranty; Removing The Cover - Chicco BabyHug 4in1 Manual

• Never mix new and old or different types of batteries.
• Always keep batteries and tools out of the reach of
children.
• Do not short-circuit the power terminals.
• Always remove flat batteries from the product to pre-
vent any possible liquid leaks from damaging it.
• Always remove the batteries if the product will not be
used for a long period of time.
• Remove the batteries from the toybar before disposing
of the product.
• Do not throw dead batteries in fire or leave them in
the environment; they must be disposed of through
waste sorting.
• If the batteries are leaking liquid, replace them im-
mediately, making sure to clean the battery compart-
ment; thoroughly wash your hands if they have come
into contact with the liquid.
• Always dispose of leaking batteries immediately: they
can cause burns or other types of injuries.
• Do not try to recharge non-rechargeable batteries:
they may explode.
• The use of rechargeable batteries is not recommended
as the toy may not work properly.
• If using rechargeable batteries, remove them from the
toy before recharging them.
• Do not leave the product outside in the rain; water will
damage the electronic circuit.
• Rechargeable batteries must be charged only under
adult supervision.

REMOVING THE COVER

27. To remove the cover from the frame of the product,
put the seat in the horizontal position (crib) and un-
fasten the plastic clips from the seat structure. To do
this it is necessary to push the tab inwards and pull
the clip down, repeating this procedure for all clips
(Fig. 27).
28. Pull the restraint system out through the fabric holes
(if present), see SAFETY HARNESS paragraph.
29. Undo the zips along the upper edge (Fig. 28).
30. Disassemble the lateral arm, pushing the pin inwards
and pulling the arm in an outwards direction (Fig.
29). Repeat this procedure for the other arm. Lift the
arm (Fig. 30) and remove from the fabric (Fig. 30a).
CLOSING THE PRODUCT
31. To close the product for storage purposes press
down on backrest recline lever "N", put the backrest
in a completely horizontal position and remove the
toybar by pressing the buttons (Fig. 31). Complete-
ly lower the seat by pressing on height adjustment
pedal "M".
WARNING: The reclined cradle must never be closed
with a child sitting in it. Remove your child from the
product before closing the frame.
THIS PRODUCT COMPLIES WITH DIREC-
TIVE 2012/19/EU.
The crossed bin symbol on the appliance indi-
cates that the product, at the end of its life, must
be disposed of separately from domestic waste, either by
taking it to a separate waste disposal site for electric and
electronic appliances or by returning it to your dealer
when you buy another similar appliance. The user is re-
sponsible for taking the appliance to a special waste dis-
posal site at the end of its life. If the disused appliance is
collected correctly as separate waste, it can be recycled,
treated and disposed of ecologically; this avoids a neg-
ative impact on both the environment and health, and
contributes towards the recycling of the product's ma-
terials. For further information regarding the waste dis-
posal services available, contact your local waste disposal
agency or the shop where you bought the appliance.

WARRANTY

The product is guaranteed against any conformity de-
fect in normal conditions of use as provided for by the
instructions. The warranty shall not therefore apply in
the case of damage caused by improper use, wear or
accidental events. For the duration of warranty on con-
formity defects please refer to the specific provisions
of national laws applicable in the country of purchase,
where provided.
19