Care And Maintenance; Warranty - Chicco 04079215570000 FAWN Instructions For Use Manual

CARE AND MAINTENANCE

This product requires periodical maintenance.
Cleaning and maintenance operations must be carried out
by an adult.
PLAYPEN
The fabric cover cannot be removed from the playpen. Use
a sponge and neutral soap to clean the fabric on the frame
and on the base. Do not wash the fabric in a washing machi-
ne or by hand. Clean the plastic components of the playpen
on a regular basis, using a wet cloth. Dry the metal parts to
avoid the formation of rust. Check the playpen on a regular
basis to make sure there are no worn or deteriorated parts; in
this case, do not use it.
WOODEN STAVES:
Do not immerse the wooden parts in water. Clean using a
wet cloth and gentle soap. Do not use bleach.
ASSEMBLY AND USE
Remove the product from the box. Place it in vertical posi-
tion as shown in figure 1.
Loosen the velcro straps on the outside of the base. Slide
the box out from the base.
With the product in vertical position, grab the two upper
opposite sides at the centre (figure 2). Lift them until lock-
ing them in a horizontal position (figure 3a). Repeat the op-
eration for the other two sides. Push the central part of the
playpen's bottom downward, until in the locking position
(figure 3b). Make sure that all four sides are properly locked:
with your hands at the centre of the upper sides, applying a
light pressure downward.
Place the base inside the playpen (figure 4).
One meshed side of the box can be opened completely
thanks to the dedicated zipper (figure 5A): the child can
easily enter and get out from the box.
WARNING: When the child is inside the box, the zipper
must be completely closed, with the slider in low position
(figure 5B).
REMOVABLE LINING
To remove the playpen's base lining, proceed as follow.
Extract the base from the playpen, position it with the
printed side facing the floor. Unfasten the Velcro straps on
the rear (figure 6) and remove the four wooden poles from
the relative pockets (figure 7). After cleaning, reposition the
wood slats in their pockets on the back and close the vel-
cro. Re-position the base on the playpen's bottom.
FOLDING THE PRODUCT
To fold the product, proceed as follows.
Remove the base from the playpen and place it, facing up-
wards, on a horizontal surface.
Raise the central handle on the bottom of the frame about
30 cm upwards. Keeping the handle raised, press the but-
tons located along the centre line of the sides of the box
one at a time (figure 8).
WARNING: the closing buttons are along the central line
of the tubes, right in the middle; to make closing easier, it
is recommended to grip the side as illustrated in figure 9,
identify the button then depress it fully.
Bring the legs closer to the centre until reaching maximum
compactness (figure 10).
Place the folded playpen on the base. Wrap the base
around the playpen and fold it, threading the Velcro straps
in the plastic rings (figure 11).
There is a fabric handle on one outer side of the box (fig-
ure 12), which is perfect for transporting the product when
closed, also when it is in the bag.

WARRANTY

The product is guaranteed against any conformity defect
in normal conditions of use as provided by the instruc tions
for use.
The warranty shall not therefore apply in the case of dam-
ages caused by improper use, wear or accidental events.
For the duration of warranty on conformity defects please
refer to the specific provisions of national laws applicable in
the country of purchase, where provided.
11