Change Filament - Flashforge ADVENTURER 3 V2 Quick Start Manual

1 . Tap [Filament], tap [Change], extruder starts
preheating.
3 . Pull out the filament as the picture
showed above.
235
Pull out filament,
feed new filament, press [OK]
OK
5 . Tap [ok] after plugging in new filament, loading
starts. When new filament come out of extruder
steadily, replace is completed, tap [OK].

Change Filament

/235℃
Press ok when new color appears
4 . Insert new filament into the filament
intake and push the filament into the
feeding wheel until resistance is sensed.
235
/235℃
OK
10
2 . Open the filament cover.
6. Put the spool of filament
on the spool holder, close
the filament cover.