Table of Contents
Advertisement
05 I Pool Heat Pump
INSTALLATION INSTRUCTIONS
Location
To gain maximum efficiency for your pool heat pump please follow all instructions
when "positioning the unit". It is also important to allow clearances for future service
and maintenance procedures.
The unit is designed for outdoor installation and should not be installed in a totally
enclosed area such as a shed, garage, etc., unless ducted and fan assisted ventilation
of the cold exhaust air is provided to ensure adequate air exchange for correct
operation. Re-circulation of cold discharged air back into the evaporator coil should
be avoided and will greatly reduce unit's heating capacity and efficiency.
The unit should be located as close as practically possible to the existing pool pump
and filter to minimize water piping. The use of 90 degree bends and short radius
elbows in the water piping should be kept to a minimum.
Mount the unit on a sturdy base, preferably a concrete slab. The base should be
completely isolated from the building foundation or wall to prevent the possibility of
sound or vibration transmission into the building. The size of the base should not be
less than the base mounting feet dimensions of the pool heat pump.
LOCATING THE INSTALLATION
ACCESSORIES
Included with the heat pump are some
installation accessories which are located
INSIDE the heat pump cabinet as shown
below.
Step 1: Locate the front panel of the unit
on the right side of the fan outlets.
Step 2: Remove the 6 locating screws
from the cabinet and slide the
compartment
two centimeters.
Step 3: Carefully pull the compartment
cover outward.
Step 4: Remove the accessories bag and
drainage piping.
cover
downward
front cover
Advertisement
Table of Contents
