Electrical; Electrical Connection; Breaker Size; Electrical Wire Size - Waterco Electroheat ECO-V Installation And Operation Manual

11 I Pool Heat Pump

Electrical

All electrical work should be performed by a fully qualified and licensed electrician
in accordance with local electrical codes.
An adequate circuit breaker and copper wiring must be used. Electrical requirements
are available on the name plate of the pool heat pump. It may be necessary to install
an earth leakage circuit breaker.
Waterco recommend connecting the unit to an isolating switch to allow ease of service
and maintenance.
THE POOL HEAT PUMP MUST BE DISCONNECTED BEFORE
!
OPENING THE ACCESS PANEL.

Electrical Connection

Standard 60 Hz power supply
Standard 50 Hz power supply

Breaker Size

Please consult name plate on the base or the side of your pool heat pump for starting
amperage and required breaker size.

Electrical Wire Size

Please consult a qualified and licensed electrician.
The power cable ground must be connected to the electrical
!
panel and to the ground lug of the pool heat pump. An
improper installation may be a potential cause of fire,
electrical shock or injury.
: 220/240 v - 50Hz-1 phase
: 220/240 v - 50Hz-1 phase