Circuit Breaker Trips; The Pool Heat Pump Is Noisy; The Temperature Shown On Pool Heat Pump Is Not The Same That Is Shown By The Pool Thermometer - Waterco Electroheat ECO-V Installation And Operation Manual

35 I Pool Heat Pump

Circuit Breaker Trips

If you have purchased a remote control (or other equipment), ensure the equipment
is correctly installed. If an operational issue originates from incorrect operation or
installation of this equipment, Waterco's warranty will not apply and you will have to
pay the cost of the service call.
1. The amperage of the circuit breaker AND the electrical wiring must be as the
instructions on the pool heat pump name plate, otherwise notify your installer or
electrician to correct this problem, as this is not covered under the warranty.
2. If the circuit breaker and electrical wiring are as stated, make sure the drains,
located under the base of the pool heat pump are not obstructed.

The Pool Heat Pump Is Noisy

1. Check the pool heat pump is level and on a solid base to prevent any vibrations
issues.
2. Ensure the noise is coming from the pool heat pump, not from other equipment
which will not be covered by the warranty (for example: noise coming from the
bypass valve, pool pump, etc);
3. An improper installation may cause this situation it will need to be corrected by the
owner.
The Temperature Shown On Pool Heat Pump Is Not The
Same That Is Shown By The Pool Thermometer
It is possible to have a temperature variation between the temperature shown on the
electronic control temperature display of the pool heat pump and a pool thermometer
which may be read from different locations.
- Check that there are no leaks on the pool plumbing (there should be no air leaks
in the pipework);