Operation With App Smartcolors - ProLights SMARTBATIP User Manual

SMARTBATIP 11
Auto transmit/receive mode
On Master unit:
• Press the MENU button so many times until the display shows S-tr then press the ENTER button.
• Press the UP/DOWN button and select dtAS. Press the ENTER button to confirm.
• Press the ENTER button again to confirm dtAU.
On Slave unit:
• Press the MENU button so many times until the display shows S-tr.
• Press the ENTER button to confirm.
• Press the UP/DOWN button and select drAS.
• Press the ENTER button to confirm.
• Press the ENTER button again to confirm drAU.
On Master unit:
• Hold the AUTO button.
On Slave unit:
• Hold the AUTO button (always hold AUTO button on Master unit).
• Wait 5 seconds and release the AUTO button on Slave unit.
NOTE - Use any one of the standalone modes for the master unit. Set the slaves to the same DMX modes.
3.11 OPERATION WITH APP "SMARTCOLORS"
Important: WIFIBOX hardware is required to use this app.
WIFIBOX is a new-generation light control system, conceived to obtain an easy and versatile platform for
LED projectors. The signal transmission is managed wired and wireless (through Wi-Fi), both in input and
output, even allowing to control the fixtures through a smartphones applications "Smarcolors", available
for IOS and Android devices.
Before using the application, check that all devices are properly configured with WIFIBOX. For device's
Fig.8