Master/Slave With Wireless Signal - ProLights SMARTBATIP User Manual

10
3.10 MASTER/SLAVE MODE WITH WIRELESS SIGNAL
This mode allows you to wirelessly connect more units SMARTBATIP, without a controller. The first unit,
transmitter signal, it will be set as master and the others, receivers, as slave.
SMARTBATIP (MASTER): SIGNAL INPUT
1) DMX (with a DMX Controller)
2) Control panel on device
3) IR remote controller
IRC REMOTE
BLACK
AUTO SOUND
OUT
SENSI-
STROBE SPEED
TIVITY
% FADE
MANUAL
SNAP
R G B
A UV W
+ 0
3
1 2
4 5 6
7 8 9
SMARTBATIP (MASTER):
TRANSMITTER MODE
(type of channel for data wireless
communication)
1) Manual Channel --> dtCH
2) Auto Channel --> dtAU
SMARTBATIP (SLAVE): RECEIVER MODE
1) drCH --> MASTER UNIT sets on Manual Channel
2) drAU --> MASTER UNIT sets on Auto Channel
Note: To work in the right way, all SMARTBATIP must be con gured with the same DMX address/mode.
Wireless communication between devices can be configured in two ways:
Manual transmit/receive mode
On Master unit:
• Press the MENU button so many times until the display shows S-tr then press the ENTER button.
• Press the UP/DOWN button and select dtCH. Press the ENTER button to confirm.
• Press the UP/DOWN button, select one of the transmitting signal dt 1 - dt 16.
• Press the ENTER button for save the setting.
On Slave unit:
• Press the MENU button so many times until the display shows S-tr. Press the ENTER button to confirm.
• Press the UP/DOWN button and select drCH. Press the ENTER button to confirm.
• Press the UP/DOWN button, select one of the transmitting signal dr 1 - dr 16.
• Press the ENTER button for save the setting.
SMARTBATIP
MASTER
SLAVE
SLAVE
SLAVE
SLAVE
Fig.7 - Configuration Master/Slave mode