Warning And Control Lamps - Seat Mii 2015 Owner's Manual

Table of Contents

Advertisement

system is not a replacement for driver aware-
ness.
Always adapt your speed and the distance
to the vehicles ahead in line with visibility,
weather conditions, the condition of the road
and the traffic situation.
The City Safety Assist function does not re-
act to people, animals or vehicles that cross
or move in the opposite direction in the same
lane.
If after switching on the City Safety Assist
function the vehicle begins to move, slow the
vehicle with the foot brake.
CAUTION
If you suspect that the City Safety Assist ra-
dar feature is damaged, switch it off. This will
avoid additional damage.
Any repair of the radar sensor requires spe-
cialist knowledge. SEAT recommends taking
your car in for technical service.
Note
If the City Safety Assist function activates a
brake, the brake pedal range is reduced. This
makes the brake pedal seem "harder".
Automatic brake intervention by the City
Safety Assist function can be cancelled by
pressing the clutch pedal, the accelerator
pedal or by a corrective intervention.
During automatic braking by the City Safety
Assist function you may hear unusual noises.
Driver assistance systems
This is normal and is produced in the brake
system.

Warning and control lamps

The City Safety Assist function is switched on
every time the ignition is switched on. No
special indication is produced.
If the City Safety Assist function is switched
off or on, or if there is an error in the system,
it will be shown by a control lamp on the in-
strument panel display.
It lights
Possible cause
Solution
›››
up
The City Safety As-
sist function has
The control lamp
been switched on
 
turns off after about
manually using
5 seconds.
the button
 
›››
Fig.
90.
Possible cause
Flashes
Solution
›››
Fast: The City Safe-
ty Assist system
function brakes
Control lamp turns
automatically or
off automatically.
has braked auto-
matically.
Possible cause
Flashes
Solution
›››
If the vehicle is stop-
ped, switch off the
engine and switch it
on again. If necessa-
ry, inspect the radar
Slow: City Safety
sensor (dirt, frost)
Assist function is
›››
not currently avail-
sor on page
able.
it still does not func-
tion, refer to a Speci-
alised workshop to
have the system in-
spected.
Within the operat-
ing area of
5-30 km/h
Switch on the City
(3-19 mph): The
Safety Assist func-
City Safety Assist
 
tion manually using
function has been
the button
switched off man-
›››
Fig.
ually using the
button
 
›››
Fig.
90.
Several warning and control lamps should
light up for a few seconds when the ignition
is switched on, signalling that the function is
being verified. They will switch off after a few
seconds.
in Radar sen-
112. If
 
90.
»
111

Advertisement

Table of Contents
loading

Table of Contents