Table of Contents
Advertisement
›››
5.
Unscrew the wing nut
Fig. 149
5
Remove the tail light from the bodywork by careful-
6.
ly pulling backwards.
Disassemble the tail light unit and place it on a
7.
flat, clean surface.
To change the bulb
Unlock the bulb holder locking tab (arrow)
›››
8.
Fig. 150
C and remove the bulb holder from the
tail light.
Replace the faulty bulb by a new identical bulb
9.
›››
Fig. 150
D.
Place the lamp holder in the tail light unit. The at-
10.
tachment tabs (arrow) should audibly click into
›››
place
Fig. 150
C.
Assembling the tail light units
Carefully insert the tail light unit into the opening
11.
in the bodywork.
Support the tail light with one hand in the assem-
12.
bly position and securely screw the wing nut with
›››
Fig. 149
B.
the other
5
Ensure that the tail light unit has been correctly
13.
fitted and is firmly secured.
Insert the connector
into the bulb holder and
2
14.
press the lock
on the connector in the oppo-
3
›››
Fig. 149
site direction to the arrow
15.
Insert the cover. The cover should lock into place.
›››
16.
Close the rear lid
page
50.
Fuses and bulbs
Changing the number plate light
B.
On the rear bumper: Remove the
Fig. 151
number plate light.
Number plate light: Remove the bulb
Fig. 152
holder.
Complete operations only in the sequence giv-
en:
B.
With one hand, press on the number plate light
1.
from left to right and remove it from the bumper
›››
Fig.
151.
Complete operations only in the sequence giv-
en:
Detach the number plate light carefully from the
2.
bumper.
Turn the bulb holder with the bulb anticlockwise
3.
and remove it in the direction of the arrow
›››
Fig.
152.
4.
Replace the faulty bulb by a new identical bulb.
Place the bulb holder in the number plate light and
5.
press in the opposite direction to the arrow as far
›››
as possible
Fig.
152.
Insert the number plate light carefully into the left
edge of the opening on the bumper. During this
6.
process, check that the assembly direction of the
number plate light is correct, i.e. the spring must
be on the right.
Insert the number plate light into the bumper until
7.
it audibly clicks into place.
195
Advertisement
Table of Contents
