Table of Contents
Advertisement
CAUTION
●
After changing a bulb, if the rubber covers
are not replaced correctly on the headlamp
framework, the electrical installation may be
Replacing the bulbs in the headlights
There is no need to remove the headlight to
replace bulbs.
Complete operations only in the sequence given:
Fig. 146
Dipped beam and main beam headlights
1.
Remove the bulb connector H4. Remove the rubber cover using
2.
Press the retaining clip
192
damaged, especially if water is allowed to en-
ter.
●
Remove the ignition key before working on
the electric system. Otherwise, a short circuit
could occur.
A
the tabs.
downwards in the direction of the ar-
D
row, and unclip sideways and remove it.
Advice
Fig. 146
the front left headlight with rubber cover:
ped beam and main beam headlights,
lights and daytime driving lights and
nal
B
Side light and daytime driving light
›››
Open the bonnet
page
143.
Turn the bulb holder in an anticlockwise direction as far as it will go and remove it, along with
the bulb, pulling backwards.
Switch off the lights and the parking light
●
before changing a bulb.
●
Take good care to avoid damaging any com-
ponents.
In the engine compartment: Rear view of
C
Turn signals (front)
dip-
A
side
B
turn sig-
C
Advertisement
Table of Contents
