Table of Contents
Advertisement
Section 2: Operating Procedures
39289
12. Slowly back bucket (#2) away from grapple
towers (#9) until the bucket is free of the grapple.
13. Shut tractor down before dismounting.
14. Replace mounting pins (#6 & #8) in the grapple and
secure with linchpins (#5 & #7).
Unhook From Euro Hitch Plate
Refer to Figure 2-5:
!
WARNING
To avoid serious injury or death:
Park bucket with grapple tines pointing down and grapple
hydraulic cylinders fully extended.
See "Long-Term Storage" on page 27 if parking
1.
bucket for long periods.
2. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 9.
3. Disconnect customer supplied hydraulic hoses from
the tractor and store on the bucket.
4. If required, manually move locking handle until
locking pins release. If Euro hitch does not have a
locking handle, locking pins should auto-release
during Step 7.
5. Return to tractor and raise bucket up 10" (25.4 cm).
6/17/21
Table of Contents
Unhook From Euro Hitch Plate (Shown with Grapple Attached)
Figure 2-5
6. Tilt front of bucket down 5 to 10 degrees below
horizontal and lower bucket until cutting edge is
touching the ground.
7.
Slowly lower bucket hitch plate until upper hitch
hooks have separated from the front loader Euro hitch.
8. Slowly back tractor away from the bucket while
making sure the loader does not interfere with the
bucket hitch plate and hydraulic hoses.
Series: GB25, GBE25, and GBE30 Grapple Buckets 380-192M
23
Advertisement
Table of Contents
