Land Pride GB25 Series Operator's Manual page 26

Section 2: Operating Procedures
Unhook Grapple
Refer to Figure 2-3:
!
DANGER
To avoid serious injury or death:
Do not let children play on or around the attachment including
when stored. Children and/or attachment can fall.
!
WARNING
To avoid serious injury or death:
Always unhook grapple on a hard, flat surface with park
stands locked down. Otherwise, the grapple could fall over
and cause serious injury or death.
1. Shut tractor down before dismounting. See "Tractor
Shutdown Procedure" on page 9.
2. Remove cotter pin (#3) and pin (#2) from hole "A" .
3. Rotate park stand (#1) down as shown and secure in
place by inserting pin (#2) in hole "B" .
4. Secure pin (#2) with hairpin cotter (#3).
5. Repeat steps 2-4 for the other park stand.
Refer to Figure 2-4:
6. Restart tractor and extend hydraulic cylinders (#1)
fully out as shown.
7. Rotate Grapple Bucket until grapple arms (#10) are
vertical as shown.
39292
22
Series: GB25, GBE25, and GBE30 Grapple Buckets 380-192M
Table of Contents
39291
8. Lower grapple until the grapple is supported by park
stands (#3) and tines (#4). If needed, adjust angle of
bucket to make sure park stands and tines are on the
ground.
9. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 9.
10. Remove linchpins (#5 & #7) and mounting
pins (#6 & #8).
11. Restart tractor and slowly lower bucket (#2) until it is
below towers (#9).
Unhook Grapple From The Bucket
Figure 2-4
Rotate Park Stands Down
Figure 2-3
6/17/21