D.3.3.6Pnc And Serial Number Writing In The Identity Card - Electrolux SKYLINE 6-10-20GN Service Manual

D.3.3.6 PNC and SERIAL number writing in the identity card
This procedure is requested when replacing a spare part UI (User interface); the PNC-SER D.3.1.4 Oven Identity Card is not written
into replacement/spare part boards and this info is needed for SKY DUO/CONNECTIVITY.
In case that we have to replace an user board UI it will be necessary to upload into the new board the Programming file,
Programming Parameters files (refer to previous chapters) and also write the PNC and Serial number.
From software version "4.4.12" the identity card is editable in regards of PNC and Serial number fields. To access in editable mode,
it is necessary to log in as Service, with service password.
In the picture above an example of identity card of a new spare part U.I installed. After P.P and P.F. upload, the PNC and SER will
have not updated and will result empty!!
Further info regarding the UI board, refer to user interface D.3 Level T, K (TOUCH SCREEN)
44
DISPLAY
BOARD
ACU-X27
C1.1 C1.2
USB - J15 OF
O/I BUTTON "SM"
USER BOARD (U.I)
USER
BOARD (U.I)
O/I ON OFF
BOARD (SM)
RECOVERY
ACU-X28