Electrolux SKYLINE 6-10-20GN Service Manual page 10

Residual risks
• The machine has several risks that were not completely eliminated from a design
standpoint or with the installation of adequate protection devices. Nevertheless, through
this manual the Manufacturer has taken steps to inform operators of such risks, carefully
indicating the personal protection equipment to be used by them. In order to reduce the
risks, provide for sufficient spaces while installing the unit.
To preserve these conditions, the areas around the machine must always be:
– kept free of obstacles (e.g. ladders, tools, containers, boxes, etc.);
– clean and dry;
– well lit.
For the Customer's complete information, the residual risks remaining on the machine
are indicated below: such situations are deemed improper and therefore strictly
forbidden.
Residual risk
Slipping or falling
Burns/abrasions (e.g. heating
elements)
Electrocution
Sudden closing of the lid/door/
oven door (if present, depending
on the appliance type)
Falling from above
Tipping of loads
Chemical
Mechanical safety characteristics, hazards
• The appliance does not have sharp edges or protruding parts. The guards for the
moving and live parts are fixed to the cabinet with screws, to prevent accidental access.
CAUTION
In case of a significant anomaly (e.g. short circuits, wires coming out of the
terminal block, motor breakdowns, worn electrical cable sheathing, smell of
gas indicating possible leakage, etc.) the operator must:
immediately deactivate the machine.
10
Description of hazardous situation
The operator can slip due to water or dirt on the
floor
The operator deliberately or unintentionally
touches some components inside the machine
without using protective gloves
Contact with live parts during maintenance oper-
ations carried out with the electrical panel powered
The operator for normal machine use could sud-
denly and deliberately close the lid/door/oven door
(if present, depending on the appliance type)
The operator intervenes on the machine using
unsuitable systems to access the upper part ( e.g.
rung ladders or climbs on it)
When handling the machine or the packing con-
taining it, using unsuitable lifting systems or
accessories or with the unbalanced load
Contact with chemical substances (e.g. detergent,
rinse aid, scale remover, etc.) without taking
adequate safety precautions. Therefore always
refer to the safety cards and labels on the products
used.