Electrolux SKYLINE 6-10-20GN Service Manual page 108

• Switch OFF the oven and then ON ; the display will show again the error EH20 but, because the appliance is now in "dEMo"
mode, it will be able to carry out some special functions:
108
Enter into the service area D.4.2 Service area of your DIGIT
oven.
• Enter into the appliance parameters area (APPL PAr)
D.4.2.1 Appliance parameters (APPL PAr).
• Set the parameter "P10 dEMo" to value "2".
• Memorize the parameter with the "0" button.
press "8" for 2 seconds to exit from the appliance
parameters area or switch OFF and back ON.
1. Press sequentially the buttons on the keypad "1", "2" and
"3".
2. The cleaning cycle is now aborted and the "EH2O" alarm
is reset.
3. Turn the oven OFF and repeat the previous steps to
change the value of the parameter "P10 dEMo" mode to
value "0" (cooking mode).
CAUTION
Once that the oven is turned back into
"cooking mode", it is MANDATORY to
launch a rinse/wash cycle to eliminate
any detergent residuals left in the cook-
ing chamber. NOTE THAT, the rinse
cycle CLn5 will last 10 minutes.