Icom IC-M423GE Instruction Manual page 67

D Receiving an Individual Call
When an Individual Call is received:
➥ The alarm sounds for 2 minutes.
➥ "RCVD INDIVIDUAL CALL" is displayed. The backlight may
blink for 2 minutes, depending on the received Category.
q Push [ALARM OFF] to stop the alarm and the blinking
backlight.
• Even if you do not push [ALARM OFF], the alarm stops after 2
minutes, and then the screen in step w is displayed.
w Push a softkey to select your desired action.
[IGN]
➥ ➥ P ush to ignore the Call and return to the normal operating
➥
mode.
• The transceiver exits the DSC mode.
• " " continues to blink and the Call is stored in the Received
Call Log.
[INFO]
➥➥➥ P ush to display the Received call information. (p. 63)
[PAUSE] (For only USA version transceivers)
➥ Push to pause the countdown.
• The softkey is displayed if the "CH Auto Switch:" item in the DSC
SET menu (p. 66) is set to "10 sec."
• Push [RESUME] to resume the countdown.
• The call is saved in the received call log.
[ACK]
➥ Push to display the "INDIVIDUAL ACK" screen to reply to
the Call. Select one of three options, depending on your
situation. See page 34 for details of the Individual Ac-
knowledgement procedures.
• Push [EXIT] to return to the normal operating mode.*
* Only USA version, the exit confirmation dialog (p. 29) is displayed.
When "INDIVIDUAL ACK" is set to "Auto TX (Unable)," the
transceiver automatically replies to the Call. In that case,
both the TX and RX calls are stored in the Transmitted and
Received Call Logs.
7
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
57