Icom IC-M423GE Instruction Manual page 60

7
DSC OPERATION
■ Making DSC calls
D Making a Position Reply call (continued)
Manual Reply:
q Enter "POSITION REPLY" in the DSC CALLS menu.
➪ DSC Calls
MENU
(Push [MENU].)
• If no Position Request call is received, the Position Reply item
will not be displayed.
• Push [EXIT] to return to the normal operating mode.
• Push [BACK] to return to the previous screen.
w Select a desired Position Request call to reply to, using
Dial or [Y]/[Z], then push Dial or [ENT].
e The Position Reply call confirmation screen is displayed.
Push [CALL] to make an acknowledgement call.
50
➪ Position Reply
(Rotate Dial, then push [ENT].)
r While transmitting the reply call, the screen shown below is
displayed, and then returns to the normal operating mode.
When no GPS receiver is connected and built-in GPS re-
ceiver* is not receiving valid position data, and both position
and time have been manually entered, the screen as shown
below is displayed. Edit your latitude and longitude position
and UTC time as follows:
*For only the IC-M423G, IC-M423GE, and IC-M424G.
➥ Push [CHG], then edit your latitude and longitude position
and UTC time.
• Select a desired number using Dial, or [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT] or Dial.
• Select N (North latitude) or S (South latitude) when the cursor
is on the 'N' or 'S' position.
• Select W (West longitude) or E (East longitude) when the cur-
sor is on the 'W' or 'E' position.