Fit The Covers To The Blm - Watkiss P2T Unpacking And Installation Instructions

B.5.3

Fit the Covers to the BLM

Figure B:27. BLM covers. Left-to-Right machine shown.
Step Action
1 Fit the outfeed cover RH.
The outfeed cover RH is held in
position by 1 x button-head screw.
2 Fit the outfeed cover LH.
The outfeed cover LH is held in
position by 1 x button-head screw.
3 Fit the outfeed cover top
The outfeed cover top is held in
position by 2 x button-head screws.
4 Left-to-Right Machines Only:
For online machines, fit the cover
assembly, link rear to the
connecting bridge.
P2T 2-Knife Trimmer
Issue 1b, June 2018
Folder cover
Drive cover
Outfeed cover top
Outfeed cover RH
Outfeed cover LH
Information
See Figure B:27.
See Figure B:21.
Page B-17
Step Action
5 Right-to-Left Machines Only:
Fit the LH, bottom, large cover.
6 Fit the drive cover to the BLM.
7 Close the folder cover.
8 Fit the stacker.
9 Turn on the BLM.
10 Uninstall the P2T from the touch
screen on the BLM.
Remove the Installation Hardware from the BLM
Information
See Section A.2.
See the BLM Service Manual.
• Touch .
MENU
• Select Supervisor Mode .
• Touch .
MENU
• Touch CONFIGURE .
• Touch .
MACHINE OPTIONS
• Touch the ' ' next to
X SIDE TRIM
(P2T) .
• Touch .
Close
• Turn off the BLM.
APPENDIX B - Uninstall the P2T