Watkiss P2T Unpacking And Installation Instructions page 19

Figure 2:3. Castor
Figure 2:4. Height of the exposed thread
P2T 2-Knife Trimmer
Issue 1b, June 2018
Transit bracket
Brake
Castor
Pivot for bracket assembly.
DO NOT REMOVE.
Foam rubber packing
Wheel gauge tool (43mm)
Use the wheel gauge tool
supplied in the tool kit to set
this dimension.
Page 2-3
Figure 2:5. Locations of the shipping bolts
Step Action
1 Remove the outer packaging
material from the P2T.
2 Remove the plastic-wrap from
around the P2T.
3 Remove the RH side cover and
the LH side cover.
Shipping bolt
Transit bracket
Fixing nut for the transit bracket.
DO NOT REMOVE
Information
Keep all of the packaging materials.
To prevent damage to the P2T when
shipped, you must use the correct
packaging materials.
See Figure 2:1.
and Figure 2:2.
• Open the top cover of the P2T.
The top cover is held open by
gas-struts.
• Remove the screw from the
middle of the top edge of the two
covers.
• Lift each cover by approximately
20 mm and then pull toward you
to remove.
• Close the top cover.
CHAPTER 2 - Unpack the P2T
Remove the Covers from the P2T