Watkiss P2T Unpacking And Installation Instructions page 61

Figure B:9. Height of exposed thread
Step Action
Remove the stacker collect table. See  in
1
P2T 2-Knife Trimmer
Issue 1b, June 2018
Wheel gauge tool (43mm)
Use the wheel gauge tool sup-
plied in the tool kit to set this
dimension.
Information
Figure B:5.
• Remove the safety pin from
beneath the stacker collect table.
A
• Loosen the orange handscrew.
• To remove, slide the stacker col-
lect table up.
Step Action
2 Put foam between the outfeed
stacker and the body of the
machine to prevent damage.
3 Remove the pivot bracket.
4 Remove the LH side cover and
the RH side cover.
5 Adjust the castors to the correct
height to load the P2T on the
pallet.
Page B-5
Information
See Figure B:6.
2 screws hold the pivot bracket to the
bottom of the P2T.
See Figure B:7. and Figure B:8.
• Open the top cover of the P2T.
The top cover is supported by gas
struts in the open position.
• Remove the screw from the mid-
dle of the top edge of both side
covers.
• Lift the side covers approximately
20mm and then pull toward you to
remove.
• Close the top cover.
See Figure B:9.
• Before you load the P2T on the
pallet, you must use the supplied
wheel gauge tool to set the height
of the 4 adjustable-castors.
APPENDIX B - Uninstall the P2T
Prepare the P2T