Watkiss P2T Unpacking And Installation Instructions page 42

Step Action Information
4 Check the side-to-side See
alignment of the P2T •
to the BLM.
•
•
•
•
•
•
•
5 When the alignment is The docking latch will operate with a positive
correct, rotate the P2T 'click'.
into the operating
position and engage
the docking latch.
6 If needed, fit the PBS/ See
P2T pivot bracket. to the
7 Fit the covers. See
to the
P2T 2-Knife Trimmer
Issue 1b, June 2018
Figure 4:15.
Put a strip of masking tape along the top of
the outfeed cover on the BLM.
Make 20-page, A4P books.
Observe where the books leave the outfeed
of the BLM. Use a pen or pencil to mark the
near side position on the masking tape.
Put a test book against this mark and use a
pen or pencil to mark the farside position.
Measure the distance from each of these
marks to the end of the outfeed cover. The
measurements must be the same.
If the measurements are different, then use a
different hole in the pivot location bracket to
move the P2T in the needed direction. The
holes are at a 7.5 mm pitch.
For example: If the distance A is greater than
distance B, then use a hole nearer to the
rear of the BLM. See Figure 4:15.
Check and adjust until correct.
Section 4.4 - Fit the PBS/P2T Pivot Bracket
BLM.
Section 4.3 - Fit the Covers to the P2T and
BLM.
Page 4-8 CHAPTER 4 - P2T Installation
Alignment of the P2T to the BLM