Watkiss P2T Unpacking And Installation Instructions page 66

Figure B:16. Castor
Figure B:17. Trim bin
P2T 2-Knife Trimmer
Issue 1b, June 2018
Transit bracket
Brake
Castor
Foam rubber packing
Back panel
Side screw
Trim bin
Page B-10
Step Action
1 Important:
When you push the P2T up the
ramps, make sure the infeed faces
to the left.
2 Push the P2T up the ramps and
onto the pallet.
3 Rotate the bracket assemblies
inward.
4 Align the threaded holes in the P2T
with the holes in the transit
brackets.
5 Loosely fit the shipping bolts.
6 Lower the lift bracket.
Information
See Figure B:13.
See Figure B:13.
When the P2T is far enough onto
the pallet, you will feel the castors
engage with a recess in the metal
channel.
• Rotate the bracket assemblies
inward.
See 'A' in Figure B:14.
• Fit the retaining bolts to the
ramp end of the bracket assem-
blies.
See 'B' in Figure B:14.
See Figure B:15.
• Turn the screw to the left until
the lift bracket is at the lowest
point.
APPENDIX B - Uninstall the P2T
Load the P2T onto the Pallet