Table of Contents
Advertisement
1.7
P2T Installation Hardware
Important:
•
Also see:
Section 1.8 - BLM Installation Requirements
1.7.1
Supplied with the P2T 2-Knife Trimmer
1.7.1.1
Mains power connection
P2T connection: IEC60320 C19 - cable and plug supplied with the machine.
•
740-016 UK : BS 1363 2.5M
•
740-017 Europe : IEC83 'Schuko' 2.5M
•
740-018 North America / Japan : NEMA 6-15 2.5M
•
For other areas, contact supplier for the correct cable.
1.7.1.2
Pivot Kit
•
914-569 KIT, (P2T) PIVOT KIT x 1. See
Figure 1:7. 914-569 P2T pivot kit - included with the P2T
P2T 2-Knife Trimmer
Issue 1b, June 2018
Figure 1:7.
1. Pivot post with M5x40
cap-head screw, M5
nyloc nut and 2 x M5
washers 12.5mm O/D
2. Pivot location bracket
with 2 x M5x12 cap-
head screws and
spring washers.
3. Pivot clamp bracket
4. Pivot bracket with 2 x
M5x12 cap-head
screws and spring
washers.
5. 3 x long cable ties
6. 3 x short cable ties
1.7.2
Additional Requirements
1.7.2.1
P2T/PBS Interface Kit for BLM
Figure 1:8. P2T/PBS Interface Kit for BLM. Supplied with the BLM600.
Note: If there is a PBS, serial number WA/PBS/0060 or later already installed, then
you do not need an additional interface kit.
1.7.2.2
For territories with supply voltage below 225V AC
•
072-306 P2T, AUX TRANSFORMER ASSY KIT x 1
See
Section C.1
for reference.
Page 1-9
7. Cover mounting
bracket and 8 x M5x12
cap-head screws with
shakeproof washers
8. Docking latch assem-
bly and 2 x M5x12 cap-
head screws with
shakeproof washers
9. Outfeed cover and 2 x
M5x10 button-head
screws with shakeproof
washers
CHAPTER 1 - Before Installation
P2T Installation Hardware
Advertisement
Chapters
Table of Contents
