Space Needed To Install The P2T; Space To Unload The P2T; Space To Install The P2T - Watkiss P2T Unpacking And Installation Instructions

1.5

Space Needed to Install the P2T

1.5.1

Space to Unload the P2T

CAUTION: Always unload the P2T from the pallet in the direction shown
Figure 1:3.
in
Put the pallet in enough space to fit the ramps and unload the P2T.
• You need a minimum length of 3735 mm (147 inches) and a minimum
width of 1100 mm (43 inches).
See Figure 1:3.
3735 mm, 147"
Figure 1:3. The space needed to unload the P2T
P2T 2-Knife Trimmer
Issue 1b, June 2018
1.5.2

Space to Install the P2T

1.5.2.1 PowerSquare and P2T 2-Knife Trimmer. Left-to-Right.
NOT TO SCALE
Connecting Bridge
500 mm, 20" is required on all sides for access.
The height is 1330mm, 52.5". An additional 500 mm, 20" is required above the machine for
service access
Page 1-6
Input for Mains Power Supply
for BLM
BLM500/
BLM550
P2T
Input for Mains
Power Supply
1895 mm, 74.5"
CHAPTER 1 - Before Installation

Space Needed to Install the P2T