Watkiss P2T Unpacking And Installation Instructions page 50

Figure 4:29. Adjustment holes for the P2T
Figure 4:30. Adjustment holes for the Book Stacker
Figure 4:31. Conveyor tie plate. Rear of the Book Stacker.
P2T 2-Knife Trimmer
Issue 1b, June 2018
Step Action
6
1
5
4
3
2 2
1
Pivot location bracket
3
4
5
6
5
4
6
3
2
1
PBS/P2T pivot bracket
7
Conveyor tie plate
Docking corner
bracket. Not used.
Page 4-16
Remove the M8x35 cap-head
screw from the PBS/P2T pivot
bracket.
Slide the PBS/P2T pivot bracket on
the wheel mount plate.
Fit the M8x35 cap-head screw.
Remove the pivot post, nut and
washers from the PBS/P2T pivot
bracket.
Move the Book Stacker toward the
BLM.
See which adjustment hole you
used to align the P2T with the BLM.
Align the hole in the conveyor tie
plate on the Book Stacker with the
required hole on the PBS/P2T pivot
bracket.
Fit the PBS/P2T Pivot Bracket to the BLM
Information
See Figure 4:25.
See Figure 4:26. and Figure 4:27.
• Make sure that the holes in the
PBS/P2T pivot bracket align to
the hole in the wheel mount
plate.
See Figure 4:27.
and Figure 4:28.
See Figure 4:29. The adjustment
holes in the PBS/P2T pivot bracket
are on the same pitch as those in
the pivot location bracket of the
P2T.
You must use the same numbered
hole to align the Book Stacker.
See Figure 4:30.
See Figure 4:30. and Figure 4:31.
CHAPTER 4 - P2T Installation