Table of Contents
Advertisement
version 1.3
ZHT 2092 - 2093 instruction manual
General
2. Delivery of apparatus
2.1 Transportation damages
During carriage the pocket hardness tester is to be handled with the usual care. To
ensure carriage without damages the device is to be transported in the original
packaging and under normal freight conditions. Pushes during carriage are to be
avoided.
At the receipt of the goods, you have to check if there are any visible damages at
the outer packaging. If the packing is alright, you can sign the receipt documents. If
you even suspect by your visual impression that damage has occurred, make a
note of the suspected damage on the delivery receipt or freight papers and get the
carrier to sign it. Moreover, the forwarding agent/courier service must be held
responsible for the damage in writing.
If a hidden damage is discovered while unpacking, you have to inform and must
held the forwarding agent / courier service immediately in the following way: "When
opening the parcel we had to notice that .... etc. etc." This superficial checking of
the goods has to be done before the time limit of the forwarding agent / courier
service expires which is normally within 7 days. However, the period could be less.
Hence, it is recommended to check the exact time limit when receiving the goods.
If there are any damages inform also immediately your authorized PROCEQ trader
or Proceq SA directly.
2.2 Extent of delivery
The following parts are included in the delivery:
• 1 hardness tester (Proceq ZHT 2092 - 2093 or Proceq ZHT 2093)
• 1 tip 0.75 mm (Bosch)
• 1 beige pressure spring 0-3 N (graduation: 10 g)
• 1 blue pressure spring 0-10 N (graduation: 20 g)
• 1 red pressure spring 0-20 N (graduation: 100 g)
• 1 certificate of manufacturer
• 1 carrying cases
last update: 03.06.2011
page 5
Advertisement
Table of Contents
