Fujitsu AUXG07KVLA Design & Technical Manual page 136

2. Set the R.C. address. (Function setting)
• Addresses will be automatically set when initially starting up this unit. In such a case, do not
change the remote controller address for the indoor unit, and keep it at the initial setting of
"00".
• Only set addresses manually when using different numbers for addresses.
Set the R.C. address of each indoor unit using the function setting. (Refer to "Remote con-
troller address setting" in
NOTES:
– Do not use the same setting value.
– Setting is reflected after the power is turned on again.
Also set the R.C. address for the remote controller. For details, refer to the remote controller
installation manual.
NOTE: In manual setting, connect up to 15 indoor units in a system.
Example of wiring method
"Contents of function setting"
Indoor unit 1 Indoor unit 2
RC AD RC AD
01 02
Remote controller
- 130 -
on page 203.)
Indoor unit 3 Indoor unit 4
RC AD RC AD
04
03
12. Group connection