EGO POWER+ CSX3000 Operator's Manual page 44

The bar should be cleaned (including bar
rails and lubricating hole) every day of use
and checked for wear and damage
(Fig. 47). Feathering or burring of the bar
rails is a normal process of bar wear.
Such faults should be smoothed with a
file as soon as they occur. A bar with any
of the following faults should be replaced.
See the section "REPLACING THE BAR
AND CHAIN" in this manual.
◾
Wear inside the bar rails which
permits the chain to lay over
sideways.
◾
Bent guide bar.
◾
Cracked or broken rails.
◾
Spread rails.
The guide bar has a sprocket at its tip
that must be lubricated weekly with a
grease syringe to extend the guide bar
life (Fig. 48 & 49). Turn the nose sprocket
while pumping the translucent yellow,
translucent red or colorless translucent
grease into the lubricating hole until the
entire sprocket has new grease. Do not
push dirt into the hole.
TRANSPORTING AND STORING
◾
Do not store or transport the chain
saw when it is running. Always
disconnect the power plug before
storing or transporting.
◾
Always place the guide bar sheath on the guide bar and chain before storing or
transporting the chain saw. Use caution to avoid the sharp teeth of the chain.
◾
Clean the chain saw thoroughly before storing. Store the chain saw indoors, in a
dry place that is locked and/or inaccessible to children.
◾
Keep away from corrosive agents such as garden chemicals and de-icing salts.
44
56V LITHIUM-ION CORDLESS CHAIN SAW — CSX3000/CSX3000-FC
47
Bar Rails
48
49
Lubricating Hole
Lubricating Hole
Sprocket in
Guide Bar Tip