Bevel Sanding - Grizzly G0936 Owner's Manual

To edge or end sand:
1.
Adjust platen tilt to desired setting (refer to
Adjusting Platen Tilt on Page 22).
2. Connect machine to power, turn it ON, and
allow it to reach full speed.
3.
Support workpiece against miter gauge and
slowly feed workpiece into sanding belt with
light, even pressure. Maintain control of
workpiece, as shown in Figures 20–21. DO
NOT force workpiece against belt.
Figure 20. Typical edge sanding operation.
Figure 21. Typical end sanding operation.
Model G0936 (Mfd. Since 06/21)

Bevel Sanding

Adjust the platen tilt to match the angle you wish to
sand on a workpiece. Always keep the workpiece
against the table and use two hands to control it.
To bevel sand:
1.
Adjust platen tilt to match angle of bevel on
workpiece (refer to Adjusting Platen Tilt on
Page 22).
2. Connect machine to power, turn it ON, and
allow it to reach full speed.
3. Support workpiece with table (and miter
gauge if operation will allow), and slowly
feed workpiece into sanding belt with light,
even pressure. Maintain control of workpiece,
as shown in Figure 22. DO NOT force
workpiece against belt.
Figure 22. Typical bevel sanding operation.
-23-