Section 4: Operations - Grizzly T27961 Owner's Manual

SECTION 4: OPERATIONS

The Model T27961 comes with
and 1 ⁄ " sanding sleeves for sanding a
1
2
variety of different curve sizes.
Spindle sanding is typically performed to
sand inside/outside curves and irregular
shapes. The oscillating sander moves up
and down as it rotates to help create a
smooth surface and more evenly distribute
wear on sanding sleeves.
Note: When installing the
sleeve on the shaft, a rubber drum is not
necessary. Sleeve mounts directly to the
spindle shaft.
To reduce your risk of
serious injury, read this
entire
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Model T27961 (Mfd. Since 02/17)
⁄ ", ⁄ ", 1",
1 3
2 4
⁄ " sanding
1
2
manual BEFORE
Using Spindle Sander
To use spindle sander:
1. Connect tool to power supply
2. Hold sander base in contact with a
stable and secure workpiece, as shown
in Figure 6, and turn it ON.
Figure 6. Securely holding sander.
3. Use speed control dial (see Figure 5)
to adjust speed between 1800 RPM (1)
and 3200 RPM (6).
4. Turn tool OFF when done.
-13
-