Mb-1158 Board; Cn-3282 Board - Sony HDC-P1 Maintenance Manual

2-7-8. MB-1158 Board

1. Remove the side panel (L) assembly and the
side panel (R) assembly. (Refer to Section 1-5.)
2. Remove the front assembly.
(Refer to Section 2-1.)
3. Remove the rear panel assembly.
(Refer to Section 2-6.)
4. Remove the DPR-315 board.
(Refer to Section 2-7-3.)
5. Remove the DPR-316 board.
(Refer to Section 2-7-4.)
6. Remove the IF-1129 board.
(Refer to Section 2-7-5.)
7. Remove the RE-268PT board.
(Refer to Section 2-7-6.)
8. Remove the AT-163APT board.
(Refer to Section 2-7-7.)
9. Disconnect the two fl exible fl at cables and the
harness from the connectors (CN6, CN7,
CN10) on the MB-1158 board.
n
Life of fl exible fl at cable will be signifi cantly
shortened if it is folded. Be very careful not
to fold the fl exible fl at cable.
10. Remove the fi ve screws and remove the
MB-1158 board.
11. Install the new MB-1158 board by reversing
the steps of removal.

2-7-9. CN-3282 Board

1. Remove the side panel (L) assembly and the
side panel (R) assembly. (Refer to Section 1-5.)
2. Remove the CCD unit. (Refer to Section 2-1.)
3. Remove the three screws and remove the
CN-3282 board.
4. Disconnect the harness from the connector on
the CN-3282 board.
5. Install the new CN-3282 board by reversing
the steps of removal.
HDC-P1
Flexible flat cable Flexible flat cable
Harness Harness
CN7 CN7
CN10 CN10
Screws (M2) Screws (M2)
PSW PSW
M2 x 5 M2 x 5
MB-1158 board MB-1158 board
PSW PSW
M2 x 5 M2 x 5
CN6 CN6
Flexible flat cable Flexible flat cable
Harness Harness
CN-3282 board CN-3282 board
2-13 (E)