Switching The Hob Off - Baumatic BMEH94I1G Instructions For Use And Installation

Switching hotplates off

Switching the hob off

Locking the control unit /
child safety lock
Pause
Changing hotplate power settings
• Select a particular hotplate by touching the
• By touching or sliding along the slide sensor you change power setting.
• When you remove the finger from the slide sensor, the hotplate starts to operate at
selected power.
• Selected hotplate must be activated.
• To select a particular hotplate, touch the sensor (E), (E1) lights.
• By touching the slide sensor (B) at the start, bring the power setting to "0". Short beep
confirms the OFF position.
• The hob is switched off by pressing the sensor (A). The sound signal beeps and all
indicators go off, except for those hotplates which are still hot and display the warning "H"
sign as an indication of the remaining heat.
• If you switch the hob off prior end of cooking session, use the remaining heat and save
electric energy.
By activating the child lock protection you can stop the operation of the appliance and the
use of hotplates, protecting the children from accidental start and eventual injury.
Activating the control unit lock
• Touch sensor (A) and activate the hob (in case it was idle). All displays indicate »0«.
• Press the cooking zone display of the front right cooking zone and the (C) sensor
simultaneously. After the beep press the front right cooking zone display again. All
displays indicate letter »L«, which disappears after a few seconds. Child lock is now
activated.
Unlock for cooking:
• Touch sensor (A) and activate the hob (in case it was idle). All displays indicate »0«.
• Within 10sec, press the cooking zone display of the front right cooking zone and the (C)
sensor simultaneously. "L" disappears from the displays. All cooking zone displays show
"0" with a flashing dot.
After switching off the control panel the child lock is active again.
Deactivating the control unit lock
• Touch sensor (A) and activate the hob (in case it was idle). All displays indicate »0«.
• Press the cooking zone display of the front right cooking zone and the (C) sensor
simultaneously.
After the beep press the (C) sensor again.
Child lock is now de-activated.
The Pause mode is not possible within the first 6 seconds after switching on.
The execution of the function is only possible if at least one cooking zone is in
operation.
Activating the Pause function
• Actuating the key (D) for 1 second, (D
The pause conditions may also be activated with cooking zone-specific errors ,
here, the error display is hidden. Also residual heat indication , special message
such as A or "no pan" are hidden, the pause has priority.
If there is a general error during the pause, the control switches off and terminates
the mode.
During the Pause function:
• Already programmed timers are stopped
• Automatic heat-up is also switched off
• The residual heat calculation and operating time limitation continue
• The LED's of other functions (timer,multi-circuist,etc...) continue illuminated depending
on the status
The Pause condition may last for max. 10 minutes. If the status is not terminated
within this time, the control switches off. The cooking zone may be switched at any
time with the key (A), a possibly activated Pause mode is then terminated.
Terminated the Pause mode
• Press sensor (D) and in 10 seconds any other key (not the same again).
This re-establish the condition before the Pause mode
sensor (E), (E1) lights.
) is statically illuminated.
1
13