Timer Function - Baumatic BSIH32-ANZ Instruction Manual

the clock.
If, while the clock is working as a count-
down chronometer, at some point the
induction plates are set at power level
the touch control panel will turn off after a
few seconds, but the chronometer will con-
tinue working until it finishes the count-
down or the countdown is cancelled.
To cancel the chronometer, simply set the
remaining time to

Timer function

This function will help you with cooking as
you will not have to be present during the
following: the timer plate(s) will automati-
cally turn off at the end of the set time. The
device has an individual timer for each
plate. This allows it to time all the plates at
the same time, if required.
The function is controlled with the time
increase/decrease sensors
(11/12) associated with the clock (7).
SINGLE plate timer
To activate the timer on one single plate,
proceed as follows:
1 With the plate powered on and the clock
turned off, touch one of the sensors
(11) or (12) corresponding to the
clock.
2 Turn on the indicator (7) displaying
At the same time, a blinking
ar on the indicators for each of the pla-
tes that are powered on.
3 In the next 5 seconds, touch one of the
sensors (4) or
ding to the plate you wish to time. The
will be set on the indicator for this
plate and the digits on the clock indica-
16
.
00
and
will appe-
(5) correspon-
tor (7) will start to blink.
4 You have a further 5 seconds to select
the time required, simply by touching the
, sensors
clock. After a few seconds, the digits on
0
clock indicator (7) will stop blinking and
the decimal point on the clock and the
timed plate will start to blink, indicating
that the countdown has started.
Once the required time has been set, be
careful not to activate any other sensor
since the device may interpret that you
wish to exit the timer function. While the
clock digits blink, you can alter their value
but do not touch different sensors other
than (11) or
Once the countdown is complete, the
timed plate will power off and a series of
bleeps will be heard that can be cancelled
by touching any of the sensors
(12) associated with the clock.
Timing more than one plate / Altering
the programmed time
During a countdown, you can alter the
remaining time or time a new plate.
1 With the Touch Control powered on and
a plate timed, touch one of the sensors
(11) or
clock.
2 The countdown will stop and the indica-
. tor (7) displays
play on the indicators for each of the pla-
00
tes that are powered up.
3 At that point, you can time another plate
or alter the remaining time on a pre-
viously time set plate. To distinguish
them, take into account the decimal
point appearing on the bottom right
(11) or (12) on the
(12).
(12) corresponding to the
. A blinking
00
(11) or
will dis-