DT SWISS R 232 ONE Technical Manual page 17

ASSEMBLING THE AIR CHAMBER
1. Lightly grease the quadring, the support rings
and the oil chamber.
2. Clamp the shock into the vice.
3. Slide on the air chamber and tighten it by hand.
→ Make sure that the support rings on the oil
chamber tab are not twisted.
→ Make sure the O-ring is not pinched between
the air chamber and the end cap.
→ If the air chamber cannot be pushed down by
hand, mount the shock in the bike, compress
it and screw on the air chamber at the same
time.
4. Take the shock out of the vice.
5. Put the SAG O-ring onto the oil chamber.
Closing steps.
Dispose all waste in an environmentally compatible
manner.
Assemble the shock to your bicycle.
Link
"1.6 Environmental protection" on page 4
R 232 ONE Technical Manual V2021.10
GREASE
17