DT SWISS R 232 ONE Technical Manual page 19

REMOVING THE SLEEVES
1. Remove the sleeves by hand.
TESTING THE DU BUSHINGS
1. Clamp the DU pin into a vice.
2. Rotate the shock on the pin to check the DU
bushing.
→ If the shock can be rotated without
resistance, the DU Bushings must be
changed. See following.
→ If the shock can be rotated with resistance,
the DU bushing must not be changed.
Check the DU bushing again within the next
small service.
Mount the sleeves again (see "Mounting the
sleeves" on page 22).
R 232 ONE Technical Manual V2021.10
19