DT SWISS R 232 ONE Technical Manual page 22

MOUNTING THE DU PIN
1. Slightly grease the inner surface of the DU
bushing and the outer surface of the DU pin.
2. Push in the DU pin by hand.
3. Position the pin centrally by clamping the pin in
the vice and while turning the shock, pushing it to
the center.
4. Wait a few minutes and check the DU bushing
again (see "Testing the DU bushings" on page
19).
If this test fails a second time, contact a DT Swiss
service center.
MOUNTING THE SLEEVES
1. Slightly grease the DU pin.
2. Slide the sleeves onto the DU pin.
Closing Steps
Dispose all waste in an environmentally compatible
manner.
Assemble the shock to your bicycle.
22
Link
"1.6 Environmental protection" on page 4
GREASE
GREASE