Factory Defaults - Pyronix ATLAS 8 PLUS Installation Manual

ATLAS 8 PLUS LED -
11
11.1

Factory Defaults

The panel is pre-programmed to the factory settings shown below.
Master User code
Manager
Engineer code
Bell timer
Bell delay
Entry
Exit
Event log
Downloading access code
Group reporting
Dial in
Zones
Programmable Outputs
System Option 1
System Option 2
System Option 3
System Option 4
System Option 5
System Option 6
System Option 7
System Option 8
System Option 11
System Option 12
System Option 13
System Option 14
System Option 15
System Option 16
Rins163 Issue 9
PROGRAMMING
: 1234 (0000-9999)
: 5678 (0000-9999)
: 9999 (0000-9999)
: 20 minutes (programmable 2 to 20 mins)
: 0 minutes (programmable 0 to 20 mins)
: 30 seconds (programmable 2 to 255 secs)
: 30 seconds (programmable 2 to 255 secs)
: Engineer reset of log
: 1234
: Group1=1, Group2=1, Group3=1
: Enabled
: End of line resistor
: Off
: End of line zone
User Log Reset Disabled
Tone Dial
Internal Sounder Only On Tamper Activation
: 24 Hour Test Dial
Dial In enabled
Timed Exit
Audible P.A. Zones
: Engineer Power Up NVM Reset
Engineer System Reset Disabled
User Omit Enabled
Door Chime On Push To Set Enabled
: Anti Code Reset Disabled
Open zone display Disabled
No alarm on line fail - STU
No alarm on line fail - PC
: Alarm Active Low
P.A. Active Low
Fire Active Low
Confirmed Active Low
: Abort Active Low
Open Active High
Spare
Spare
: Alarm Restoral Reporting Off
P.A. Restoral Reporting Off
Fire Restoral Reporting Off
Confirmed Alarm Restoral Reporting Off
: Abort Restoral Reporting Off
Spare
Spare
Spare
: Alarm On
P.A. On
Fire On
Confirmed Alarm On
: Abort Alarm On
Set / Unset Off
System Faults Off
: Alarm On
P.A. On
Fire On
Confirmed Alarm Off
: Abort Alarm On
Set / Unset on
System Faults Off
: Alarm On
P.A. On
Fire On
Confirmed Alarm Off
: Abort Alarm On
Set / Unset off
Page 31