King Industrial KC-122FC-LS Manual page 9

BASE AND COLUMN ASSEMBLY (FIG.6)
1. Position the base on the floor. Remove the protective covering and
discard.
2. Remove protective sleeve from the column and discard. Place the
column assembly on the base, align the holes in the column support
with the holes in the base.
3. Locate three long bolts from the parts bag.
4. Install a bolt in each hole through the column support and the base
and tighten with an adjustable wrench.
5. Locate table crank and support lock in loose parts box.
6. Install support lock from left side into the table support and
tighten by hand. (Fig.7).
7. Install table crank assembly and tighten set screw with a hex. key.
Do not overtighten. The set screw should be tightened against the
flat section of the shaft. NOTE: To minimize crank backlash,
tighten support lock, rotate elevation worm shaft clockwise, then
assemble crank tight against the table support and tighten set
screw.
8. Check column collar for proper adjustment. The collar should not
be angled on the column and it should be positioned so the rack
will slide freely in the collar when the table is rotated 360
the column table. If re-adjusted, only tighten set screw enough to
keep the collar in place. NOTE: To avoid column or collar damage,
do not overtighten set screw. (Fig.8).
INSTALLING THE TABLE (Fig.9,10)
1. Loosen support lock and raise table support by turning the crank
clockwise until the support is at a working height level. Tighten
support lock.
2. Remove protective covering from the table and discard. Place table
against table support making sure the stud go through the slots of
the table. Fix the table to the table support using nuts and washers.
ASSEMBLY INSTRUCTIONS
Support lock
0 around
Support lock
Table support
Base
FIGURE 6
Column
Table support
FIGURE 7
Column collar
Rack
Column
FIGURE 8
Column
FIGURE 9
Table
FIGURE 10
Column
Table support
Elevation worn shaft
Handle
Table crank
Do not
overtighten
set screw
Table crank
Rack
Table support
Nut & Washer