Maximum Controls MAX Ultra Arm Manual page 5

Heavy Duty 2" Tubular Stainless Steel
Loosen adjustment screws on limit switches and slide switches until approprate Limit LEDs
when finished. Adjust Slow Down switches to your personal preference.
Slow Down Switch NOTE: Is adjusted to control length of slower gate speed before limit switch gets activated.
Adjustment Screw
Two Limits Switch System
Limit
Switch
TWO INST ALLA TION OPTIONS
PULL OPEN
INSIDE PROPERTY
pull open dimensions
OPEN
Limit Switch Limit Switch
Easy mechanical release with the key
CLOSED
Closed
The Housing Made of Aluminum
MUST be ON.
OFF
1
2
3
4
5
6
Adjustment Screw
1
2
3
4
5
6
7
8
9
10
lights up. Tighten limit screws
OFF pull open dimensions
Limit
Switch
Loosen adjustment screws on limit switches and slide switches until approprate Limit LEDs lights up. Tighten limit screws
when finished. Adjust Slow Down switches to your personal preference.
Slow Down Switch NOTE: Is adjusted to control length of slower gate speed before limit switch gets activated.
Adjustment Screw
Limit Switch
push open dimensions
OPEN
Limit Slow
Switch Down
Switch
Cycle operator OPEN and CLOSE a few times and readjust limits and slow downs if necessary.
Reinstall limit cover.
MAX Ultra Arm V1
Closed
Limit Cover
Remove limit cap with 2 screws
and slide limit cover off operator.
PUSH OPEN
Adjustment Screw
OUTSIDE PROPERTY
Limit Switch
Slow Limit
Down Switch
Switch
Closed
Limit Cap
MOTION CONTROL
OPEN CLOSE
STOP
19
CLOSED