Close The Housing - JUMO ATH-SE Series Operating Manual

5 Installation
5.2.2

Close the housing

1. Make sure that the plastic gasket in the lower part of the housing (B) is checked for correct fit.
NOTE!
On the thermostate with code -70, the external reset button (C) must be located precisely on top the
internal reset button (D) on the microswitch. Only in this way can the restart button be actuated from the
outside (C).
2. Place the upper part of the housing (A) onto the lower part (B).
3. Tighten the lead-sealable cheese-head screws (E).
18