Epson LQ-670 User Manual page 141

Follow the steps below to perform bid irectional ad ju stm ent.
Not e:
To print the instruction sheet and alignment patterns, you need
four sheets of A 4 or letter size single-sheet paper or 11-inch or
longer continuous paper. (See Chapter 3, "Paper Handling," for
instructions on loading single-sheet or continuous paper.)
If you use single-sheet paper, be sure to load a new sheet of paper
each time the printer ejects a printed sheet. Otherwise, you
cannot proceed to the next step.
1. Make su re p ap er is load ed , then tu rn off the p rinter. While
hold ing d ow n the Pa use bu tton, press the Op era te bu tton
to tu rn on the printer. The p rinter enters the bid irectional
ad ju stm ent m od e and then prints the instruction sheet and
the first set of alignm ent p atterns.
2. As d escribed on the instruction sheet, com p are the alignm ent
p atterns and select the p attern w ith the best alignm ent. To
sp ecify the p attern num ber you w ant, press the LF/ FF
bu tton (to d ecrease to the num ber) or the Loa d / Ejec t
bu tton (to increase to the num ber) until the Font lights
correspond to the correct nu m ber as ind icated at the
bottom of the instruction sheet.
3. Press the Font bu tton to save you r selection and p rint the
next set of alignm ent p atterns. Then rep eat step 2 to select
the best alignm ent p attern.
4. Press the Font bu tton again to save you r selection and p rint
the final set of alignm ent patterns.
5. Select the best pattern in the final set of alignm ent patterns
as d escribed in step 2 and then p ress the Font button to
save your selection.
6. Press the Op era te bu tton to tu rn off the p rinter and exit the
bid irectional ad justm ent m od e.
Troubleshooting
7
7-25