When you press button (4) to confirm the fourth and
last digit, the MEM item frame is flashing.
Now use buttons (1), (2) and (4) to do the following:
-
keep button (2) pressed for 2 seconds to quit the
function without saving the PIN code;
-
select every figure (flashing) of the set code and
press button (4) to edit them and repeat the
code entry procedure;
-
select MEM (flashing frame) and press button
(4) to save the new PIN CODE.
Then the instrument panel shows "PIN MEM"
for 2 seconds and goes back to the previous
screen.
To exit and go back to the previous screen, keep
button (2) pressed for 2 seconds.
Note
You can change your PIN CODE an unlimited
number of times.
114
1
4
2
Fig 66
1
4
2
Fig 67