System Features - Supermicro FatTwin F619P2-FT User Manual

1.4 System Features

The following table provides you with an overview of the main features of the F619P2/3-FT.
Please refer to Appendix C for additional specifications.
Motherboard
X11DPFF-SN
Chassis
F418IF3-R2K20BP
CPU
Dual 81xx/61xx/51xx/41xx/31xx or 82xx/62xx/52xx/42xx/32xx processor which offer 2 UPI (UltraPath
Interconnect) of up to 10.4GT/s
Note: Both CPUs need to be installed for full access to the PCI-E slots, DIMM slots, and onboard controllers. Refer to the
block diagram on page 16 to determine which slots or devices may be affected.
Socket Type
Socket P0
Memory
Integrated memory controller embedded in the processor supports up to 1.5 TB of 3DS Load Reduced DIMM
(3DS LRDIMM), Load Reduced DIMM (LRDIMM), 3DS Registered DIMM (3DS RDIMM), Registered DIMM
(RDIMM), and NVDIMM DDR4 (288-pin) ECC memory of 2933/2666/2400/2133 MHz in 12 slots
Chipset
C621 chipset
Expansion Slots
The X11DPFF-SN motherboard has the following expansion slots available.
One PCI-E 3.0 x16 slot supported by CPU 1 (JPCIE4)
One PCI-E 3.0 x8 slot supported by CPU 1 (Slot2)
One PCI-E 3.0 x16 Super I/O Module slot supported by CPU 1 (SIOM)
Two NVMe for PCI-E high-speed storage devices with option for two more drives, supported by CPU2 (PN-NVMe 0/1/2/3)
One Riser card header for SDD1 devices
Note: only two slots are available in the front for use.
Hard Drives
The amount and type of hard drives per node in the system depends upon the model number as follows:
F619P2-FT: either two or four 2.5" SATA3 or NVMe drives
F619P3-FT: two 3.5" SATA3 drives
Power
Four 2000 or 2200 Watt redundant power supplies
Cooling
Up to eight 8-cm hot-swappable 13.5K RPM cooling fans shared by the system's eight serverboard nodes
Form Factor
Proprietary: 18.73" (L) x 8.54" (W) (475.74 mm x 216.92 mm)
Dimensions
(WxHxD) 17.63 x 6.96 x 29 in. (448 x 177 x 737 mm)
System Features
11
Chapter 1: Introduction