FAAC 624BLD Manual page 8

Display Function
P1
OUTPUT 1 POLARITY:
for configuring the output polarity status.
Y
= N.C. polarity
n o
= N.O. polarity
Note: if the output is set to FAIL-SAFE (
leave the default value.
o2
OUTPUT 2:
See output 1.
P2
OUTPUT 2 POLARITY:
See output 1 polarity.
o3
OUTPUT 3:
See output 1.
P3
OUTPUT 3 POLARITY:
See output 1 polarity.
o4
OUTPUT 4:
See output 1 , except to functions
12
that in this case have not effect.
P4
OUTPUT 4 POLARITY:
for configuring the output polarity status.
Y
= N.C. polarity
n o
= N.O. polarity
AS
ASSISTANCE REQUEST (coupled to the
next two functions):
If activated at the end of the count-down
(settable with the next two functions under
"Cycle programming"), it activates LAMP
output for 4 sec every 30 sec. Can be
useful for setting scheduled maintenance
Y
= Active
no
= Excluded .
nc
CYCLE PROGRAMMING IN THOUSANDS:
For setting a count-down of the system
operating cycles. Settable value from
99
(thousands of cycles). The displayed
value is reset as the cycles progress, inte-
racting with the
menting steps correspond to one
crement).
The function can be used combined with
n C
, to check the use of the system and
to make use of the "Assistance request".
8. MASTER-SLAVE
Default
00
)
00, 11 ,
0
to
n C n c
value (99 decre-
n C
de-
Function
Display
no
n C
CYCLE PROGRAMMING IN HUNDREDS OF
THOUSANDS:
For setting a count-down of the system
operating cycles. Settable value from
99
to
The displayed value is reset as the cycles
progress, interacting with the
(1 decrement of
03
decrements of
The function can be used combined with
n c
no
make use of the "Assistance request".
h 1
NO EFFECT
01
h 2
NO EFFECT
no
S t
AUTOMATED SYSTEM STATUS:
Exit from programming, storage of data
02
and return to gate status view (see par.
5.1.).
no
6. START-UP
6.1. LEDS CHECK
The following table shows the status of the LEDs in relation to the
no
status of the inputs (the closed at rest automated system condition
is shown in bold).
Check the status of the signalling LEDs as per table below:
Note that:
Operation of status signalling LEDs
00
LED Description
DL1 OPEN
DL2 CLOSE
DL3 FSW
DL4 STOP
DL5 EMERGENCY
DL6 FCA
DL7 FCC
DL8 PIVOT
7. AUTOMATED SYSTEM TEST
When you have finished programming, check if the system is operating
correctly.
Above all, check if power is adequately adjusted and if the safety
devices operate correctly.
17
(hundreds of thousands of cycles).
n c
n C
corresponds to 99
n c
).
to check the use of the system and to
L = closed contact
ed on
L = open contact
ed off
ON (closed contact)
Command enabled
Command enabled
Safety devices released
Command disabled
Command disabled
Opening limit switch free Opening limit switch engaged
Closing limit switch free Closing limit switch engaged
Beam attached
Default
0 1
0
value
oo
oo
OFF (Open contact)
Command disabled
Command disabled
Safety devices engaged
Command enabled
Command enabled
Beam detached
Fig. 10