Advertisement
Quick Links
Advertisement
Related Manuals for FAAC 410 MPS
Summary of Contents for FAAC 410 MPS
- Page 1 410 MPS 410 MPS UNI EN ISO 9001-085...
-
Page 2: General Safety Regulations
17) Each installation must be fitted with at least one flashing light (e.g. FAAC LAMP, MINILAMP etc.) as well as a warning plate suitably fixed to the gate, besides the safety devices as per point 16. above. -
Page 3: Description And Technical Specifications
ENGLISH DESCRIPTION AND TECHNICAL SPECIFICATIONS LAYOUT AND ELECTRICAL WIRING Table 1: 410 MPS Control unit technical specifications Power supply 230 V(+6%-10%) - 50 Hz Absorbed power 10 W Max. motor load 800 W Max. accessories load 0,25 A Temperature range -20 °C +55 °C... - Page 4 (fig. 3). the zone behind the gate leaves (A, fig. 3). The 410 MPS card has an additional FAIL-SAFE device which CL. - Closing safety device contact (N.C.): in the A-S-E-EP-AD serves to check that the N.C. contact on the photocell...
- Page 5 ENGLISH Application examples The following are the commonly used connection arrangements (disable fail -safe) One pneumatic edge connected as closing safety device and No safety device connected one connected as opening safety device 14 15 14 15 — — OP — CL OP —...
- Page 6 N.B. If the STOP devices are not connected, jumper STOP and - inputs. – Common ( - ) 410 MPS 410 MPS A - TWO-LEAF OPENING (N.O.): all devices (pushbuttons , photocells, detectors, etc.) which assures opening/closing of both leaves by closing a contact.
- Page 7 M1 (see fig. 2) to ensure correct closure of the gate. Fig. 15 Set the delay by the LEAF DELAY trimmer on the 410 MPS control unit (fig. 1 - ref. 8). To reduce delay time, adjust the trimmer anticlockwise.
- Page 8 ENGLISH (*1) If residual pause time is less than 5 seconds on safety disengagement, the gate closes after 5 seconds. N.B.: Effects of other active impulse inputs are shown in brackets...
- Page 9 ENGLISH...
- Page 10 Le descrizioni e le illustrazioni del presente manuale non sono impegnative. La FAAC si riserva il diritto, lasciando inalterate le caratteristiche essenziali dell’apparecchiatura, di apportare in qualunque momento e senza impegnarsi ad aggiornare la presente pubblicazione, le modifiche che essa ritiene convenienti per miglioramenti tecnici o per qualsiasi altra esigenza di carattere costruttivo o commerciale.