Supermicro SuperServer E302-9A User Manual page 60

SuperServer E302-9A User's Manual
NVDIMM Battery
Inactive - charging
LAB Start Location
LAB
Size(MB)
*The feature above is not available when the Method feature is disabled.
Test NonVol Mode:
Use this feature to force a nonvolatile memory flow. The options are Disable, ADR re-
covery, ADR-C2F save, and ADR-C2F restore.
Fast Boot
Use this feature to enable or disable fast path through the memory reference code. The
options are Enabled and Disabled.
Command Address Parity
Use this feature to address the DDR4 command parity. The options are Disabled and
Enabled.
Memory Frequency
Use this feature to set the maximum memory frequency for onboard memory modules. The
options are DDR-1600, DDR-1867, DDR-2133, and DDR-2400.
MMIO Size / BMBOUND Base
Use this feature to select the memory mapped IO size and BMBOUND base setting. The
low for the two settings will always be 4GB. The options are Auto, 1024M/3072M, and
3072M/1024M.
TCL Performance
Use this feature to enable the CAS Latency (tCL) to increase memory performance. The
options are Disabled and Enabled.
Memory Preservation
Enable this feature for the memory content to be preserved through a warm reset. The
options are Disabled and Enabled.
Patrol Scrub Enable
Patrol Scrubbing is a process that allows the CPU to correct correctable memory errors
detected in a memory module and send the correction to the requestor (the original source).
When this item is set to Enable, the IO hub will read and write back one cache line every
16K cycles if there is no delay caused by internal processing. By using this method, roughly
64GB of memory behind the IO hub will be scrubbed every day. The options are Enabled
and Disabled.
[Fixed LAB]
[0]
[1024]
60