Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLY
5
Carefully route the Gas Hose
Head and Upper Post Assembly
the Lower Post/Post Support Plate Assembly
Control knob on Head Assembly should be located over the
Tank Housing Door.)
6
Attach Head Assembly and Upper Post Assembly
the Lower Post
E
by aligning the 4 small holes located
on the Upper Post with the 4 small holes located on the Lower
Post. Insert 4 M6x12 Bolts through 4 M6 Lock Washers and into
holes and tighten with a wrench.
Hardware Used: 4x M6x12 Bolt and M6 Lock Washer
7
Assemble Reflector Panels and Center Cap
Panels and Center Cap come packaged in two brown
boxes with two panels in each box. Hardware for assembly
is already affixed to each panel. Place two panels side by side
and remove the two cap nuts and washers that are affixed to
one panel. Insert the affixed bolts into the open holes on the
adjacent panel. Place the washer over the bolt and screw on
cap nut. Repeat these steps until all four panels are assembled.
Then locate the Center Cap. You will need to remove the cap
nuts and washers located at the top of each Reflector Panel
to allow assembly of the Center Cap on each panel. Align the
holes in the Center Cap with the bolts on each panel and affix
washer and cap nut to complete assembly. (Note: It is easiest to
assemble reflector panels if you turn panels upside down and
assemble on a soft surface. Once 4 panels are assembled, turn
reflector right side up and then attach the cap.)
Contact us for assistance: (866) 985-7877 | www.balkenehome.com
C
that comes attached to
B
completely through
/
. (Hint:
E
F
B
to
. Reflector
A
B
C
E
/
F
B
E
A
8
Advertisement
Table of Contents
